P80 Slide Sticking
BlogP80 Slide Sticking - I have a slide drag issue but my trigger bar isn't getting hung up on the plunger. The hump in the trigger bar is catching on the chamber opening section of the slide and. In a pinch you can punch both all 4 of p80 pins out and literally pull the slide off the frame. There are no polymer rail sections that hold the slide to the frame, just the front and real rails which. If the p80 slide is working on your glock you can be pretty sure the problem is with your build. On my g26 build the trigger works and resets fine, but when you pull the slide all the way to the rear it gets stuck just a tiny bit before the slide stop would catch in its notch. You can try to. Check the firing pin safety in the slide. If it is binding you can have all sorts of trigger and slide problems. The plunger seems to be moving freely in its bore when moved by hand. The slide release spring should curve around the end of the slide release and arc upwards. The end of the spring should stick out towards the rear. You should see the tip. It appears the shelf. It's most likely your barrel doesn't like your slide. Take your barrel and slide off and drop the barrel in with no recoil spring. Does it fit easily into battery with the slide/ barrel hood flush. Iโve currently built a p80 g17 with both the frame and slide completed. However, iโm having some trouble getting the slide to go on correctly. When i attach the slide to the.
I have a slide drag issue but my trigger bar isn't getting hung up on the plunger. The hump in the trigger bar is catching on the chamber opening section of the slide and. In a pinch you can punch both all 4 of p80 pins out and literally pull the slide off the frame. There are no polymer rail sections that hold the slide to the frame, just the front and real rails which. If the p80 slide is working on your glock you can be pretty sure the problem is with your build.